Quote:
Originally Posted by varmonter
The neck at the nut measures 1.97 in.
with my caliper. so almost two inches.
The neck is c shaped thinner at the
top. The fretboard i was told has a slight
compound radius. Not much fretwear.
|
Hi, just poking my nose in here, being a 12 fret dread nut. The nut width on the D18.28.35 - "S" models were 1 & 7/8" =1.875" which was always the standard for Martin standard scale 12 fret models, until the HD28VS came out with a 1 & 3/4" nut width.
Also the neck profile on the D35-S was a "C" profile, and I believe it was the same neck on all three.
Hope this helps (exit - pursued by a bear).