[johnny oxford]

Hi there, new here, first posting.

My son uses a roland micro cube rx for busking, along with a little martin lx1e which has fishman isys preamp onboard.

He usually runs a microphone into the normal input of the amp, (the amp has a "mic" setting) - and the martin guitar into the "aux input" on the back of the amp.

This works fine, the volume of the guitar is controlled by the onboard volume pot, and the volume of the amp by the main volume control on the RX cube.

He has just got a Vox Lil Looper loop pedal, he chose it as it runs off batteries and can take a mic or guitar input.

HOWEVER

it can only take either or guitar or mic, and you have to switch between them with a little switch on the back of the pedal (presumably changes the impedance range it is looking for).

He would like to be able to connect both the guitar and amp to the pedal, not to use at the same time, but at least to have the ability to create vocal loops as well as instrumental.

So to cut a long story short, he needs a small mixer of some description which will take a microphone and an electro acoustic guitar signal, and "flatten" them into a single signal

It also needs to run off battery.

Does such a thing exist?

I will be happy to answer any further questions, I may not have explained it that well, and we are open to other suggestions, main thing is it must be battery powered and relatively small so it can go on a pedal board.

Hope you can help, I have searched the forum a bit, and read some interesting stuff - but nothing specifically that helps.