Another thing to be aware of just in case you run into this issue...
I had a Pedaltrain...nice board! A Voodoo Labs' ISO 5 fit nicely underneath. My pedals laid out nicely, but there was this very odd, very low buzz in my signal chain. Could not figure out which pedal was causing it at first...all tested fine by themselves.
So, then I played with placement...bingo! The culprit? The ISO5 in near proximity to pedals with inductors! I had a wah pedal and a direct box on top...both use inductors. Get either pedal close to the top side near the ISO5 and there it was...the ISO5 switching power supply was being induced into the inductor of any pedal close. Moved the pedals and noise was gone.
BradM
__________________
<{()}>< <{()}>< <{()}>< <{()}>< <{()}><
bradM - SW Ohio - love to pick!
<{()}>< <{()}>< <{()}>< <{()}>< <{()}><
|