So after re-reading the label about 8 times, i finally spot that my mineral spirits contain oil.
If I plan to lacquer this at the end, I'm guessing I need to somehow remove this from my wood even though its now soaked in and I can't see the stain any more
Any suggestions on how I would best go about this? dish soap with not much but warm water? sanding? actually oil the top fully and prepare to utilise a non-lacquer finish? this is not my number 1 option as my client would prefer a semi-gloss finish, and in my impressions that much easier to obtain via lacquer then by shellac/french polishing or oil lacquer etc.
|