Joining Plates/Bending Sides/Neck Blank
Continued...
The side layout is drawn on the side using a template.
After being cut to profile, the sides are bent over the mold with a heat blanket.
They are then placed in a cooling jig to cool.
The mahogany-maple-walnut-maple-mahogany neck sandwich is glued up.
Order Up: One five-piece neck sandwich ready for cutting and carving.
__________________
Martin 00-18G (1949); Eastman 805 Archie; Waterloo WL-S; Furch Green OM (Sitka/EIR); Tahoe Guitar Co.: OM (Adi/Mahog); 000-12 (Carpathian/FG Mahog); 000-12 (Lutz/Flame Maple); 00-12 (Carpathian/Sinker Mahog); 00-14 (Adi/Ovangkol)
"I can tell you all I know, the where to go, the what to do
You can try to run but you can't hide from what's inside of you"
Last edited by OddManOut; 01-19-2015 at 03:28 PM.
|