Quote:
Originally Posted by IBKuz
Mark, what is the bit you are using here? The tip looks to be what I would see on a drill bit, but the shaft is closer to the spiral on a cutting milling bit. I'm am assuming you are routing the slot here and not just drilling holes and clearing the material between manually.
|
Hi Ian, You’re correct, I am using a drill bit there. I am installing an 11/64ths thick saddle. I am drilling an 11/64ths hole on either end of the slot to set the floor depth and width of the slot. This also gives me nice round ends. I then come back with an 1/8” router bit to cut the slot using the holes as reference.
Mark