Thread: Nut shim up
View Single Post
  #12  
Old 12-06-2017, 10:50 PM
StevenL StevenL is offline
Registered User
 
Join Date: Nov 2012
Location: Monroe, Louisiana
Posts: 1,305
Default

Just did the mailing label thing with the nut on my Guild. Luthier had cut it just a tad too low. I had read this thread a while back and found some labels. String change tonight. Nut off, label in, nut on, buzz free.

While I had the nut off, I sanded the top down so that the strings weren't buried in the slot like Luthier had it done and carefully widened the slots a hair and smoothed them out. Some were pretty jagged. Good grief. $40 for this.

Joy = well set up nut.

Thanks Frank for the tip and others for bringing it up here.
Reply With Quote