New LP standard with bad nut carve..
At my local GC there was a brand new LP standard and the low E was sitting slightly off the fret board. You had to bend the string to be able to fret a note. I understand that Gibson had some QC challenges but seriously? How did this make it to a showroom floor?
LP standards aren't exactly inexpensive instruments. Hopefully this was just a one off. |
Wow - any chance that the nut isn't glued in correctly and the entire nut shifted towards the low E side? Perhaps not, the string tension might not allow that to happen.
|
I just picked up a new LP Standard 50's from Sweetwater. Factory setup working for me for now. Resonant as heck. Loving it. :)
|
I received my 50s Standard a couple of weeks ago and it was flawless.
|
Quote:
|
Made the drive up to Sweetwater last Sat and picked up my new '50s Standard in Cherry sunburst. She's perfect. :)
|
Sure sounds like the nut slipped, or Gibson's QC has slipped further down that slippery slope!
|
All times are GMT -6. The time now is 06:00 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ©2000 - 2022, The Acoustic Guitar Forum