Removing nut without damaging finish
I want to change the nut on my Guild F-412
It looks like the headstock was finished after the nut was installed. I can see just a little bit of a fillet of finish where the peg head veneer meets the nut. How can I remove the nut without chipping the finish? |
You have to razor blade the edges of the nut, so you have a break here point for the finish
Steve |
A utility knife with a fresh blade is easy -
|
We like to use an exacto knife with a freshblade. Lay a piece of tape down so you have an edge to follow.
|
All times are GMT -6. The time now is 09:08 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ©2000 - 2022, The Acoustic Guitar Forum