#16
|
||||
|
||||
Quote:
I wanted it to be 1/2" on the inside and 5/16" on the outside. Just for a tighter fit on the auxilliary output. I only wanted it to protrude enough to get the nut an washer on. The strap button one is a normal hole, of course. In other words, I wanted the jack to fit more like this since it wasn't getting a strap button. Just wanted a flush output. I did a similar thing on a Taylor a while back but it had a custom plate to use.
__________________
Bryan Last edited by bnjp; 08-09-2017 at 04:33 PM. |