#1
|
|||
|
|||
How much to shave off the saddle bottom when installing a Baggs Element?
I am measuring 33 mils with my calipers but I imagine it might compress a bit under string pressure. I am thinking I should take the saddle down 1/32". Does this sound about right? I am putting a Mi-Si Trio into a new RainSong H-DR1100N2. The factor setup is right where I want it. Thanks!
__________________
jf45ir Free DIY Acoustic Guitar IR Generator .wav file, 30 seconds, pickup left, mic right, open position strumming best...send to direct email below I'll send you 100/0, 75/25, 50/50 & 0/100 IR/Bypass IRs IR Demo, read the description too: https://youtu.be/SELEE4yugjE My duo's website and my email... [email protected] Jon Fields |
#2
|
|||
|
|||
Quote:
|
#3
|
|||
|
|||
That brings me to 32 mils. I've got several spare RainSong spec Tusc saddles and I'll take one of them to duplicate the factory saddle minus 1/32".
__________________
jf45ir Free DIY Acoustic Guitar IR Generator .wav file, 30 seconds, pickup left, mic right, open position strumming best...send to direct email below I'll send you 100/0, 75/25, 50/50 & 0/100 IR/Bypass IRs IR Demo, read the description too: https://youtu.be/SELEE4yugjE My duo's website and my email... [email protected] Jon Fields |
#4
|
|||
|
|||
I always just snug them up with calipers and use that measurement. Works just fine that way.
|