#1
|
|||
|
|||
Problem with piezio under saddle pick up
I recently replaced the plastic saddle on my Ovation clone with a tusq replacement.Trouble is I amgetting no dignal from the low E and high E.The other four strings are fine.Any ideas?
|
#2
|
|||
|
|||
make sure it's sanded flat on the bottom and that it's properly seated in the bridge. Also make sure the pickup filament is properly seated under the saddle
__________________
The Velcro Lunchbox http://www.reverbnation.com/museric?...eader_icon_nav https://www.youtube.com/channel/UCxt...-_xka6GsUr9v4Q https://soundcloud.com/museric-1 Breedlove American C25/SSe Delgado Candelas Jumbo Eastman AC420 Eastman E10D Eastman E10SS Fender (MIM) Stratocaster |
#3
|
|||
|
|||
Ok I will check it out thanks!
|
#4
|
|||
|
|||
Good signal in the middle and none at the ends is definitely a contact problem. Hope you get it resolved before it drives you nuts.
__________________
Journey OF660, Adamas 1581, 1587, 1881, SMT - PRS Cu22, Ibanez JEM-FP, S540, RG550, Fender Stratocaster Heil PR-35 : Audio Technica AE-6100, ATM5R : Beyer TG-V90r : Sennheiser 441, 609, 845, 906 : ElectroVoice ND767 HK 608i Friedman WW Smallbox, Marshall 4212 |
#5
|
|||
|
|||
Yes it is kind if a strange problem!
|
#6
|
||||
|
||||
Piezo wires can be a bit fragile too. Did you move the pickup wire while changing the saddle?
__________________
Fazool "The wand chooses the wizard, Mr. Potter" Taylor GC7, GA3-12, SB2-C, SB2-Cp...... Ibanez AVC-11MHx , AC-240 |
#7
|
|||
|
|||
__________________
|
#8
|
|||
|
|||
No',I did not remove or touch the pick up in the slot.I did sand the saddle down so It might not be making proper contact due to leveling issues.
|
#9
|
|||
|
|||
Ok!problem solved.Turns out the bottom of the replacement was not square so I flattened it out on a piece of glass with 180 grit sandpaper taped to it.I checked it with the blade of my combination square and when it was right I reinstalled it.All six strings now amplify properly.Thanks for the helpful tips and advice!
|