#1
|
|||
|
|||
How difficult to bend bloodwood?
I'm planning an L-00 build for my first acoustic this year. I'm going with sitka over EIR because the consensus seems to be that EIR is kindof a go to wood for some teachers because it's ease of bending makes it easier for a first timer to be sucessful (and I like Sitka over EIR, LOL).
I would like to use bloodwood for the binding (LMI stock). How easy does it bend? Is it close to EIR in those terms? Easier? More difficult? I'll be bending on a hot pipe. Thanks
__________________
Mike The only thing nescessary for evil to thrive is for good men to do nothing |
#2
|
|||
|
|||
pretty much the same.
|
#3
|
|||
|
|||
If its binding stock itll be fine.
I love Bloodwood, check out my build in my sig for some Bloodwood. The bridge and headstock to be exact. When wet or finished its rich looking.
__________________
A few 'horses from Montana... |
#4
|
||||
|
||||
My experience says it wants to break easier than EIR. I have a lot of broken pieces to prove it. I recommend Super Soft 2, as an assistance to reducing breakage. A lot depends on the amount of runout in the pieces you have. If you are using a bending machine, with support on both sides your luck may be better. I bend by hand on a pipe.
__________________
Waddy |
#5
|
|||
|
|||
Thanks for all the help and replies. Much appreciated.
WaddyT, got the same advice re: Super Soft on another forum I frequent. Looks like a no-brainer to me. Thanks to all.
__________________
Mike The only thing nescessary for evil to thrive is for good men to do nothing |
#6
|
||||
|
||||
Yeah, I saw that. Didn't figure I needed to repeat it. Veneer Suppliers has SS2.
__________________
Waddy |