#1
|
|||
|
|||
k&k mini not working
Very frustrated. I installed a k&k mini pickup in my e20 d Eastman. It works great on my small amp at home, but when I plug it into our church sound system and 2 other smaller amps at church there is no sound or signal.
I had the same setup on another guitar and it worked great on the church sound system. I'm using the same cord on all amps and didn't make a diff if it's run through a preamp or not. Any ideas? |
#2
|
|||
|
|||
I understand your frustration. If your K&K works fine with any one amp your installation must be right. Are you shure the end pin jack sticks far enough out of your guitar?
Last edited by Karel; 07-05-2015 at 09:31 PM. |
#3
|
|||
|
|||
k&k mini not working
Think I found the problem. Short in one of the wires going to a sensor. Now to try to remove the superglued sensors. Fun fun
|