#1
|
|||
|
|||
1971 Alvarez 5014 successful neck reset!
Yay!! Got this at a thrift store for $30 (as seen in a previous thread) and I have just successfully removed and reset the neck on this guitar.
Plays well and sounds amazing. Very mellow and warm! Great guitar! IMG_4282 by [url=https://www.flickr.com/photos/35595445@N04/] IMG_4283 by [url=https://www.flickr.com/photos/35595445@N04/] IMG_4324 by [url=https://www.flickr.com/photos/35595445@N04/] |
#2
|
|||
|
|||
Nice rescue.
|
#3
|
|||
|
|||
This is awesome! How possible would this project have been if you didn't have access to the tooling/knowledge of the shop? I have a great little sigma I'm looking to reset the neck on in the next year or two.
Sent from my iPhone using Tapatalk |
#4
|
|||
|
|||
What kind of neck joint does it have?
__________________
Brian Evans Around 15 archtops, electrics, resonators, a lap steel, a uke, a mandolin, some I made, some I bought, some kinda showed up and wouldn't leave. Tatamagouche Nova Scotia. |
#5
|
|||
|
|||
It was glued in with three dowels holding it in.
|
#6
|
|||
|
|||
1. Assuming it was epoxied, how did you apply heat to loosen it up?
2. With the dowels stuck in fixed holes, how did you accommodate the position shift when you lowered the heel to allow the dowels to remain straight? I'm looking at resetting what I believe is a doweled butt joint in a 70's Conn, so any details you could provide would be helpful. Thanks in advance. |
#7
|
|||
|
|||
Quote:
No Big Deal, you say? Well: the fingerboard extension had a dovetail that slid into a socket in the neck block! I have photos of this gig somewhere, I'll see if I can find them when I get back.
__________________
|
#8
|
|||
|
|||
Quote:
If you've got pics, that would be fantastic. Thanks Jeff. |
#9
|
|||
|
|||
Great conclusion to a fantastic job. Beautiful guitar!
|
#10
|
|||
|
|||
Looks like a good deal! I have an Alvarez 5014.
|