#1
|
|||
|
|||
How to install K&K w/ 2 5/16 bridge spacing
Getting a Martin OM-28V and planned to install a
K&K mini but realized their template? Is probably made for a smaller width. Any advice? I've never put one in before. Major thanks. I set actions, lower saddles, file and replace nuts etc. so comfortable doing this myself. Just know getting this right matters. |
#2
|
||||
|
||||
Quote:
|
#3
|
|||
|
|||
Thanks. Duh: I should have downloaded the instructions first. Very clear. Only question is whether there is enough space on the bridge plate to put the transducers on the sound hole side of it without overlapping the edge of it too much. Best is full contact with the bridge plate.
Thanks Pastor. I have learned a lot reading your posts. Sent from my R1 HD using Tapatalk
__________________
The journey is ending. It has been a lovely ride. Enriched my life immensely. No words. |
#4
|
||||
|
||||
It sounds to me that it will work on a small bridge. Out of all the posts on a couple of forums I have never heard of it not being able to be accomplished.
Make sure you cover the guitar well so as not to drip glue on it. Use the gel super glue not the thin stuff. Be very careful when you enlarge the hole for the input jack.
__________________
Waterloo WL-S, K & K mini Waterloo WL-S Deluxe, K & K mini Iris OG, 12 fret, slot head, K & K mini Follow The Yellow Brick Road |