#1
|
|||
|
|||
Clean boost in signal chain
'morning.
I'm currently going like this with my acoustic guitar set-up: GTR > Boss TU2 > BBE OptoStomp > EHX LPB-1 > EHX Neo Clone > Marshall RG1 > EHX Memory Toy > DI > PA So I'm basically boosting the signal (when needed, fingerpicking or solos) before modulating it. This sounds better to my ears than effecting the signal and THEN boosting it. I know there's no right or wrong way to do it, but I'm curious as to where acoustic guitarists put their booster in the chain. Thoughts ? |
#2
|
|||
|
|||
Quote:
__________________
Rick Ruskin Lion Dog Music - Seattle WA |
#3
|
|||
|
|||
I run tu2 - mxr line driver - cs3 compressor - super octave - overdrive - chorus - delay - wah - looper - eq/direct box - pa. Use for acoustic and also same setup for electric to my guitar amp. Tried line driver at end also and preferred in front also. Could not tell you exactly why ? Fun toys !
|
#4
|
|||
|
|||
Geez, why didneyetinkovdat. I had not given a single thought to put the boost between tunah and compressah.
thx ! *mad-dashing it to the studio* |