View Single Post
  #11  
Old 01-11-2017, 10:44 PM
printer2 printer2 is offline
Registered User
 
Join Date: Dec 2012
Location: Middle of Canada
Posts: 5,098
Default

Too lazy to make up some templates, just winged it by using a construction square as my guide.



I guess I was too involved with the routing and not wanting to screw up I never took any pictures while making little wood chips. Just drew out a rough guide where to cur and went at her. Still have to drill between areas and do a hole for the output jack. Otherwise coming along well enough. I did not sand the body edge smooth as that only invites dents. I'll do that once I am done with the rough shaping.

__________________
Fred
Reply With Quote