View Single Post
  #8  
Old 04-20-2012, 06:28 PM
stephenT's Avatar
stephenT stephenT is offline
Charter Member
 
Join Date: Feb 2005
Location: GA & MN
Posts: 4,655
Default

Quote:
Originally Posted by Kitchen Guitars View Post
Doing it right is the best way. But, a alt method is get a Japan saw, its a cheap flexible handsaw at Harbor Freight. Cut the heel to the fret board. Bend back the neck to check angle. If you need more angle slide in some sand paper and remove media till the angle you want is achieved. Use SLOW Epoxy to glue the angle in place.
Ah,.. I'll have to think about that. But I get the drift.

Thanks to all who took the time to respond!

Last edited by stephenT; 04-20-2012 at 08:30 PM.
Reply With Quote