View Single Post
  #19  
Old 01-10-2017, 11:16 AM
clintj clintj is offline
Registered User
 
Join Date: Oct 2012
Location: Idaho Falls, ID
Posts: 4,071
Default

Thank you.

I wired the input jacks this morning. I use the chassis to hold the jacks still, so I can work freely. The method I use uses the leads of the 1M resistors to connect everything here. Learned that one during my tweed Deluxe build. Just have to make sure the resistor will be clear of the cable when inserted.







I also built a ground bus for the preamp section of the board this morning. It's a more modern system than the old school brass plate Fender used, and is far easier to install. Soldering to the plate or even the chassis takes a really powerful iron.



The part that will pass under the jacks has a piece of heat shrink insulation, just in case.

Sent from my SM-G920V using Tapatalk
__________________
"You don't have to be great to start, but you have to start to be great." -Zig Ziglar

Acoustics
2013 Guild F30 Standard
2012 Yamaha LL16
2007 Seagull S12
1991 Yairi DY 50

Electrics
Epiphone Les Paul Standard
Fender Am. Standard Telecaster
Gibson ES-335
Gibson Firebird
Reply With Quote