Don't worry about it. Just set them where you need them.
An arbitrary algorithm, no doubt there are better:
- Turn off the K
- Use the line level output of your mixer to connect to the line level input on the K.
- Set the K controls to 12 o'clock
- Set the K equalization to front-of-house or flat if on a pole, or monitor if on the floor
- Set the mixer master to zero.
- Set all the mixer channel controls to 12 o'clock
- Reduce the trim control on any mixer channel that is lighting its overload light
- Turn on the K
- Set the mixer master to desired room volume
- Then tweak everything else on the mixer to taste.