Quote:
Originally Posted by Halcyon/Tinker
If I'm looking at it correctly, the second last pic has the wide bolt holes showing out, to demonstrate how little clearance there is? If so, it would concern me as well.
I would lop off the truss rod hole in the top of the block, then redrill, then trim the bottom of the block to fit. Don't forget to match the angle on the bottom, and to make sure you have the wide end of the holes facing inwards...
|
I'm afraid by trimming the front and moving it forward I would rob the tennon of room and scoot the fingerboard toward the soundboard too far making it impossible to fit flush the fingerboard and soundboard ...
apparently the precut 14 fret necks have a longer tenon than the 12 frets
still thinking on this
My only option may be to trim the back.
Sent from my iPhone using Tapatalk Pro