Quote:
Originally Posted by redir
Cool thanks for that. I wish I had known that when I started. I presume the type of support is pertinent. In my case as you can see the supports are a 'point' so I imagine that is better than a square though maybe it doesn't matter. Also does the weight have to be dead center? I imagine that the dial gauge would have to be center too but of course that is not possible with my set up. They could be very close though.
|
Take the brick and epoxy a thin flat piece of wood or metal to the side.
Then lay the brick dead center on the wood and take your measurement off of the thin flat piece you've epoxied to it.
Now you'll be able to get a dead center measurement.