Quote:
Originally Posted by Neil K Walk
You took the sides out of the mold to do a test fit of the mortise only, correct? Without the top and back glued to the sides they will flex and the blocks will therefore move in relation to one another. Don't attempt to set the neck angle until the box is closed.
|
Yes it was to test the mortise only and to see how it looked together. I just couldn't resist.
But even when they are in the mold it is still angled towards the right of the end block. By more than I would assume that is acceptable.
I guess that I just need to proceed forward and that I should correct it with taking the necessary amount off of correct side of the neck where it meets the body when I get to that point. Correct?