View Single Post
  #4  
Old 11-15-2006, 08:08 PM
tony_cb tony_cb is offline
Registered User
 
Join Date: Mar 2005
Location: Niagara Falls, Canada
Posts: 152
Default

Hi Paul,

Here are a couple of screenshots of the EQ settings I use with my T5. The first is when I use position 1 or 2 for acoustic sounds. The second is when I use position 4 or 5 for clean electric sounds.

There isn't much difference between the two, just cut the mids a bit more with the electric sounds. With no EQ I found the bass was too loud so I needed to drop that end quite a bit. I also rolled off some of the highs as it was a bit too bright. Then I followed the curves that Eltjo (Picker2) published here a while ago with a broad drop in the mids with a narrow lift around 1 kHz to brighten it up a bit.

Hope this helps. Don't forget this is works for my setup and you will have to listen to your own to get the best settings for your system.



__________________

Photos of my Guitars


Taylor K14CE-L7
Taylor 854CE-L7
Taylor T5-C2 Koa
Collings OM2HG
Fender Deluxe Strat
Breedlove AN250CR SYN
Gretsch 6120 JR2
Breedlove AN250/CR SYN
Warwick Thumb Bass
Reply With Quote