Thanks again Charles
I haven't actually come up with a specific method yet but I already know that i can't use the same technique as the back has a radius.
I had thought i could basically invert what i did to glue the top and use the same flexible board i had under the guitar (contouring to the back curve) while i was clamping the top and place that on top of the back and clamp to a thicker board under the guitar.
I was thinking about possibly using spool clamps, but a) i dont have any b) they are expensive to buy and will probably take ages to make and c) i'm actually not convinced these will work well unless the back is trimmed basically almost flush before you even glue it on and i'm not sure i can trim it close enough accurately enough in advance to use this method
Dave
|